Guide: How to Use the Dragon Mechanical Mod

Welcome to the Vapor Puffs guide on how to use the Dragon Mechanical Mod. We’ll start off by giving a brief introduction to the parts of the Dragon Mechanical Mod and then move onto showing you how it works.

What is the Dragon Mechanical Mod?

Made entirely out of copper in order to increase conductivity, the Dragon Mechanical Mod is a fully analog mod sized for 18650 batteries.


  • Threading Connection – At the top of the Dragon is a 510 threading connection that can be removed by twisting it counter-clockwise. Your atomizer will connect to this part. On the inside, a silver plated contact can be found.
  • Battery Tube – This is where your battery will go. It can be accessed by removing either cap at the top or bottom.
  • Firing Button – Found at the bottom, the Dragon’s firing button works a little differently than most. Rather than having a spring that requires you to hold the button down, it’s just pushed in or left out, without the need for you to hold it down. With this new firing button idea, the Dragon also has a lock mechanism which is activated by twisting the firing button to the right while it is in the off position.

How To Use The Dragon Mechanical Mod

  • Insert the Battery

Remove the firing button by twisting it counter clockwise. Then, insert your battery with the positive side facing the atomizer side. Re-attach the firing button.

  • Attach Your Atomizer

Now, grab your atomizer and attach it to the threading connection at the top. While connecting, make sure the firing button is not pushed in.

  • Begin Vaping

Now with everything connected, push in the firing button. The vaping process should start, and everything should come naturally at this point.

Thanks for Reading Our Guide on How to Use the Dragon Mechanical Mod!

We hope we’ve helped you figure out how to get it working.

Buy it Here: Dragon Mechanical Mod

Happy Vaping!

Leave a Reply

Your email address will not be published. Required fields are marked *